本页面标准信息均来源于网络收集，或由参与标准制定的供应商提供，只作为参考使用，为确保测试结果的准确性、节省您的时间，如需ASTM D5110-98标准详细信息或ASTM D5110-98具体测试方法，欢迎致电与我们技术人员联系或给我们留言，我们将为您相关的技术支持。
ASTM D5110-98简介
ASTM D5110-98是关于臭氧监视器校正以及紫外光照射产生臭氧水平认证的的标准，标准后续所带的数字为标准*新修改被采用的年份。出于版权保护原因，本文仅摘抄部分ASTM D5110-98英文标准，如需完整ASTM D5110-98内容请购买请垂询客服人员。
ASTM D5110-98英文原版摘录
1. Scope
1.1 This practice covers a means for calibrating ambient, workplace, or indoor ozone monitors, and for certifying transfer standards to be used for that purpose.
1.2 This practice describes means by which dynamic streams of ozone in air can be designated as primary ozone standards.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 8 for specific precautionary statements.
2. Referenced Documents
ASTM Standards
D1356 Terminology Relating to Sampling and Analysis of Atmospheres
D3195 Practice for Rotameter Calibration
D3249 Practice for General Ambient Air Analyzer Procedures
D3631 Test Methods for Measuring Surface Atmospheric Pressure
D5011 Practices for Calibration of Ozone Monitors Using Transfer Standards
E220 Test Method for Calibration of Thermocouples By Comparison Techniques
E591 Practice for Safety and Health Requirements Relating to Occupational Exposure to Ozone
E644 Test Methods for Testing Industrial Resistance Thermometers
